Figured out the CRT screws are a type called “#8”, hopefully these ones are correct. I’ll update with how they go. The minimum order quantity was 100, but thankfully they weren’t too pricey.

One issue with the second display bracket I printed, is the metal chassis that screws into the front bezel interferes with the lower two mounting points… Really don’t want to dremel the chassis as I’d prefer everything I’m doing to be reversible, but I may not have an alternative in terms of reliably keeping the LCD panel in place.

I’ve ordered the capacitors I need to recap the MLB I’m using, as it needs it - there is evidence of the current ones having leaked - I’ll be giving the board a good clean as part of that process.

Also, I’m now 3D printing a holder that will fit an SD card extension cable, such that I can easily swap the SD card that will be in the BlueSCSI device that acts as a SCSI hard drive my colour SE/30 will boot from.

Currently listening: nook - “fy_resort | Intelligent DnB / Jungle Mix”