Designing and 3D printing a Hard Drive Spacer

One other thing I wanted to fix with the old Sony Vaio laptop was figure out a solution for the missing hard drive bracket…

It’s the sort of random part one might eventually spot an original of on eBay as the bracket (Sony Part Number 4-674-033-01) does seem to be used in quite a few different Vaio laptop models, but most likely pay far too much for.

So, I fired up PrusaSlicer to design and then print my first project - all it is a happy little cuboid to keep the IDE SSD from sliding out of place, but you gotta start somewhere! :)

Currently listening: Zorrovian - “✨Cosmic Curation✨ (Ambient, Jungle, Jazzy, 90s DNB mix)”

Jonathan Wrigley @workswellforme